TechNews: SeamShield Contractor Benefits
SeamShield facts
- Easy-to-remove films that leave a residue-free surface that is ready to weld.
- A 6-inch transparent blue film on the top ply allows overlap lines and fastener marks to be easily seen for installation.
- A 3-inch white film contrasts with the black bottom ply.
- A split top film accommodates both mechanically fastened and adhered installations. The split transparent top film allows plates and fasteners to be installed directly through the film in mechanically fastened installations with a 2.5-inch strip that can be removed when the seam is ready to weld. In adhered applications, the entire top film is removed prior to welding.
- SeamShield clean seams increase seam weld strength versus traditional cleaned seams.
- VersiWeld TPO with SeamShield technology is available in 10’- and 12’-wide sheets in 45-, 60-, and 80-mil thicknesses and the standard colors of white, gray, and tan.
- Once installed, the film should be removed within seven days.
- Enhances productivity by eliminating the time and materials required for cleaning seams.
- Improves ergonomics through a reduction in the time spent bent over during the cleaning process.
- Improves weld consistency by providing a factory-clean seam at the time of welding.
SeamShield technology is a great addition to any job and is particularly suitable for re-roofing applications where the presence of additional dirt can lead to prolonged cleaning times. Furthermore, it minimizes the need to protect the seam area from excess adhesive in adhered applications, where overspray can prolong cleaning durations.
For more information about SeamShield, check out the following resources:
SeamShield page
VersiWeld TPO with SeamShield vs. Standard Cleaning Time Trial Video
VersiWeld TPO with SeamShield Sell Sheet
SeamShield FAQs
VersiWeld TPO with SeamShield Protective Film Technical Data Bulletin
Up Next
TechNews: Thermal Bridging
It has always been good roofing practice to install your roof insulation in two or more layers and to stagger joints of insulation boards. Installing one thick layer of insulation allows for more thermal loss between the joints of the insulation from the roof deck level to the membrane level.
TechNews: Changing Insulation R-Value Requirements for Commercial Roofs
It can be difficult to keep up with the latest insulation R-value requirements for commercial roofs. These requirements vary by state and are periodically updated to reflect new rules, laws, and standards. Versico has resources that can help.
TechNews: Cutting APEEL Protective Film
Versico’s APEEL Protective Film guards the surface of TPO or PVC membrane from scuffs and dirt accumulation during installation, but it is critical that the film is cut properly around penetrations and accessories to avoid damaging the membrane.